Highlander center dash panel reattachment.

Reply
 
LinkBack Thread Tools Display Modes
Old 01 Feb 2010, 08:44 am   #1 (permalink)
Rush Wickes
Guest
  • Posts: n/a
  • User Status:


Default Highlander center dash panel reattachment.

I recently replaced my factory installed 2002 Highlander radio with an
aftermarket one from Crutchfield. The installation of radio and it's
cradle went exactly to plan. I let some professional installers take
care of the door speakers, they did a good job as well.

I noticed that the center dash panel, which surrounds the heating
controls and radio unit, is no longer flush with the surrounding dash.
One side or both sides (left and/or right) protrudes about 1/2 inch from
adjacent surfaces. I don't think I did anything in error while removing
it.

All eight clips (four up top around the hazard and passenger seat belt
lights, two below the center vents on the sides and two at the bottom
below the radio) that attach the back of the panel into their retaining
slots on the dash are intact.

How can I get this panel securely back in place so the clips hold? The
new radio install does not appear to be out of alignment or causing any
protrusion and I know I'm aligning the clips up with their respective
slots.

Thanks!
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -5. The time now is 08:15 am.

Attribution:
Autoblog
Powered by Yahoo Answers



ToyotaLexusForum.com is an unofficial community for car enthusiasts. ToyotaLexusForum.com is not affiliated with Toyota Motor Corporation in any way.
Toyota Motor Corporation does not sponsor, support, or endorse ToyotaLexusForum.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.