Which line is press & return on AutoTrans cooling on radiator?

LinkBack Thread Tools Display Modes
Old 08 Dec 2004, 10:36 pm   #1 (permalink)
  • Posts: n/a
  • User Status:

Default Which line is press & return on AutoTrans cooling on radiator?

90 camry Auto V-6
Which line is return and pressure on the trans fluid cooling line to
Can a fuel line hose be used for the trans fluid cooling lines to
Is there difference on hose type for carrying dextron ATF vs. gas????

  Reply With Quote
Old 09 Dec 2004, 08:20 am   #2 (permalink)
  • Posts: n/a
  • User Status:

Default Re: Which line is press & return on AutoTrans cooling on radiator?

Use the correct hose. Fuel line may not fail, but why risk it? Possible
failure modes could be swelling or leakage at fittings.
Those hoses rarely need replacement anyway.
If you really need to know which is supply and return, I'd guess the
one on the driver side is supply - temporarily disconnect it, run the
end into a bucket, let the engine idle for a few seconds and confirm
that tranmission fluid is pumped out. Then top up the fluid with the
transmission at operating temperature. If the fluid were pumped out of
the open end of the cooler in the base of the radiator, would mean the
other hose was the supply (pressure) line.

  Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

All times are GMT -5. The time now is 07:21 am.

Powered by Yahoo Answers

ToyotaLexusForum.com is an unofficial community for car enthusiasts. ToyotaLexusForum.com is not affiliated with Toyota Motor Corporation in any way.
Toyota Motor Corporation does not sponsor, support, or endorse ToyotaLexusForum.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.