92 Camry slopply axle

LinkBack Thread Tools Display Modes
Old 24 Feb 2006, 03:36 pm   #1 (permalink)
  • Posts: n/a
  • User Status:

Default 92 Camry slopply axle

My 1992 2.2L AT Camry shakes really hard accelerating through 45-60mph.
I can feel it wobble a little at lower speeds, it's more subtle and
seems to follow the wheel speed.

I had all new tires put on, didn't help at all. I suspected the engine
mounts since the dogbone was shot, so I replaced the front (totally
shot), rear (seemed ok), and dogbone. This helped just a little, the
shaking is still really bad. There isn't any clicking when I turn, so
I had ruled out the CV joints, but I took a peek anyways and replaced
the intermediate shaft bearing (blown) but that didn't help.

I did notice that on the driver side that the tripod case, the part at
the engine end of the shaft just before the tranny, was really sloppy
in the transmission. Putting my hand on the tripod case i can move it
1-2cm in any direction. Is this likely the cause of my problem? It
seems strange that parts in the transmission would be able to move so

Thanks for any ideas or suggestions, I've run out of possibilities at
this point.

  Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

All times are GMT -5. The time now is 08:07 am.

Powered by Yahoo Answers

ToyotaLexusForum.com is an unofficial community for car enthusiasts. ToyotaLexusForum.com is not affiliated with Toyota Motor Corporation in any way.
Toyota Motor Corporation does not sponsor, support, or endorse ToyotaLexusForum.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.