93 Toyota truck ....changing motors new motor is carborated need help please?
I have a 93 Toyota truck I am changing the motors in it and putting in the same size motor but it is carborated. I am not sure how to do the wiring since the old motor was not carborated and the new one is....Can anyone out there please help me? Serious answers only please!!!
have a 93 Toyota truck I am changing the motors in it and putting in the same size motor but it is carborated. I am not sure how to do the wiring since the old motor was not carborated and the new one is....Can anyone out there please help me? Serious answers only please!!! Will the intake off the efi fit on the carborated head?
The only reason that I am changing this over is becuase the old motor is junk and this is the only other motor that I have available from my racing mud truck.
Do you want it to run a carb ? If you want the carb, then you'll have to bypass whatever fuel injection sensors the car has. But, because it's a '93, there might not be many...
It would be alot easier to just take all the efi stuff off the old engine and put it on the new...There,s way too much wiring to deal with....Too many things to go wrong...The efi is alot more fuel efficent than the carb and the power of efi setup cannot be matched....Most people go from carb to efi...I think your crazy and doing it backwards....
ToyotaLexusForum.com is an unofficial community for car enthusiasts.
ToyotaLexusForum.com is not affiliated with Toyota Motor Corporation in any way.
Toyota Motor Corporation does not sponsor, support, or endorse ToyotaLexusForum.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.
Welcome to our forum
If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.