i just changed the front disc brake pads and rotors on my 2000 corolla and the mechanic said the rear drums still have 45% left on them so i didn't have the rear changed. I'm not exactly sure if this problem was present before the brake change or not but i noticed that my brake is really spongy and i have to press it about 90% down to get a good brake response and after 90% it is really stiff and makes it hard for me to judge how hard i am braking before locking the wheels. This is important cause my car lacks ABS. I have heard that changing the brake fluid and bleeding the lines helps my brakes be more sharper and less spongy but my receipt from the brake job indicates that they did change the brake fluid and did bleed the lines!? so im wondering whether i should take it to toyota instead and ask them to bleed the line and change the brake fluid or just to ask them to inspect the brakes? i know there is a 80$ diagnostic charge if no problem is found and im wondering whether i should risk it?
whoever changed your brake pads and rotors must have not followed the proper procedure to bleed brakes. OR did it half assed. i suggest taking it back to them, and telling them politely to do it again, or have a technician try and press the brakes and see what he thinks about it. if its obvious to you , it should be obvious to him. if u took it to a good shop, theyll re do it for you at no cost.
you may have air in your brakes system,noot a big deal just bleed the brakes,did you remove a caliper when you did the change,it could also just e the brakes you got,did you go cheap?cause you get what you pay for,
ToyotaLexusForum.com is an unofficial community for car enthusiasts.
ToyotaLexusForum.com is not affiliated with Toyota Motor Corporation in any way.
Toyota Motor Corporation does not sponsor, support, or endorse ToyotaLexusForum.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.
Welcome to our forum
If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.