replaced ignition coil, distributor, and igniter and still don't have spark on my 92 toyota
camry with a v6? The car over heated and ceased to run after doing so. have changed all Components mentioned and still no spark. Does this model have a crankshaft sensor if so where would that be located. I have the chilton repair manual but it doesn't refer to the 3vzfe model which is the one i own. Any help would be greatly appreciated.
you might want to check if it jumped timing/broke timing belt, causing the camshaft position sensor to not get an accurate reading, or check if the ecu is not working.
ToyotaLexusForum.com is an unofficial community for car enthusiasts.
ToyotaLexusForum.com is not affiliated with Toyota Motor Corporation in any way.
Toyota Motor Corporation does not sponsor, support, or endorse ToyotaLexusForum.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.
Welcome to our forum
If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.