I recently changed the brake pads in the car but after that the engine light and the brake light would not come of on the dashboard any ideas? Thanks for the help
If the motor is running rough it could be the vvt sensor , keep the motor clean on the inside & outside & if it continues to run bad don't run it unless a mechanic checks it out & tells u what the code means ,
was the engine light "ON" before the brake job? Generally the engine light doesnt have anything to do with the brakes - its probably got a separate problem. The brake light is turned ON by the parking brake being set - or partially set. Make sure it is fully released and the switch is working. The brk lt is also turned on by LOW fluid or a failed fluid sensor. Check 'em out.
ToyotaLexusForum.com is an unofficial community for car enthusiasts.
ToyotaLexusForum.com is not affiliated with Toyota Motor Corporation in any way.
Toyota Motor Corporation does not sponsor, support, or endorse ToyotaLexusForum.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.
Welcome to our forum
If this is your first visit, be sure to check out the FAQ by clicking the link above.
You may have to register before you can post: click the register link above to proceed.
To start viewing messages, select the forum that you want to visit from the selection below.