Hello Rebecca,
1) Remove the negative battery cable connector from the battery with a crescent wrench. This cuts off power to the Camry's starter.
2) Remove the wiring harness from the starter solenoid by pulling the wire connector off the male connector on the solenoid.
3) Disconnect the black grounding wire from the side of the starter by removing the bolt with a crescent wrench.
4) Remove the three bolts that secure the starter to the bell housing with a 9/16 socket.
5) Pull the old starter out of the bell housing and then place the new starter into the bell housing. Torque the bolts to 27 ft. lbs. (37 Nm).
6) Install or connect the following parts:
Starter cable
Electrical connectors
Actuator connector and clamp, if equipped with cruise control
Battery and tray, if equipped with cruise control
Cheers!
www.toyotapartseast.com
how to replace a starter in a 2002 toyota camry le v6?
Linear Mode
