Popping out of gear

Reply
 
LinkBack Thread Tools Display Modes
Old 15 Aug 2009, 12:06 pm   #1 (permalink)
Video
Guest
  • Posts: n/a
  • User Status:


Default Popping out of gear

Sorry if this has been hashed out before..My 1990 4x4 4cyl is popping
out of gear. I've replaced the plastic bearing at the bottom of the
shifter (I don't remember what it was called) and it didn't help. I
do need to replace the center-bearing on the drive shaft though. Could
the center-bearing be the issue?
  Reply With Quote
Old 17 Aug 2009, 05:49 pm   #2 (permalink)
Rastamon
Guest
  • Posts: n/a
  • User Status:


Default Re: Popping out of gear


"Video" <dyost@persuasionstrategies.com> wrote in message
news:71e2f477-1eac-4645-8f86-92021561dc58@o6g2000yqj.googlegroups.com...
> Sorry if this has been hashed out before..My 1990 4x4 4cyl is popping
> out of gear. I've replaced the plastic bearing at the bottom of the
> shifter (I don't remember what it was called) and it didn't help. I
> do need to replace the center-bearing on the drive shaft though. Could
> the center-bearing be the issue?


I don't know what the center bearing has to do with your problem. I'd say
it has to do with the clutch. I had a similar problem, with it popping out
of gear. Then after replacing the shifter bushing, it was gone.


  Reply With Quote
Old 18 Aug 2009, 09:50 am   #3 (permalink)
Handyman
Guest
  • Posts: n/a
  • User Status:


Default Re: Popping out of gear

On Aug 15, 9:06*am, Video <dy...@persuasionstrategies.com> wrote:
> Sorry if this has been hashed out before..My 1990 4x4 4cyl is popping
> out of gear. *I've replaced the plastic bearing at the bottom of the
> shifter (I don't remember what it was called) and it didn't help. *I
> do need to replace the center-bearing on the drive shaft though. Could
> the center-bearing be the issue?


These are the two parts that normally need to be replaced to resolve
this issue. I have also seen where the two steel pins in the aluminum
housing that the shifter seats into have become loose over time. I
had to replace that housing at around 180,000 miles on my 1991 V-6
truck. One of the causes for this failure is the gear shift boot
tearing and allowing road grime and dust to enter the housing and
transmission from under the truck. Check to make sure your inner boot
is not torn while you are in there.

33505-35020 Seat
33548-31010 Bushing
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -5. The time now is 08:00 pm.

Attribution:
Autoblog
Powered by Yahoo Answers



ToyotaLexusForum.com is an unofficial community for car enthusiasts. ToyotaLexusForum.com is not affiliated with Toyota Motor Corporation in any way.
Toyota Motor Corporation does not sponsor, support, or endorse ToyotaLexusForum.com in any way.
Copyright/trademark/sales mark infringements are not intended or implied.